Reasonable manufacturer instruction but pictures say more
Beware of wires! always drill from inside and remove the inner skin & filling before drilling the outer skin.
These will just push aside when installing mast sleeve
[You must be registered and logged in to see this image.]position base so holes will miss any wires
[You must be registered and logged in to see this image.]drill pilot holes for screws ( the 3 short ones supplied were just a bit too short so I replaced them )
[You must be registered and logged in to see this image.]Fit the cover and gaiter using the 3 long screws provided
[You must be registered and logged in to see this image.]view inside
[You must be registered and logged in to see this image.]Angle adjustment fitting is still used regardless. Mine has a flat roof so fitted to suit
[You must be registered and logged in to see this image.]tighten up the screw collar and drive in the screws
[You must be registered and logged in to see this image.]Fit the mast through the roof and fit the locknut inside
[You must be registered and logged in to see this image.]
by 
Subject: Status 530 aerial fitting 
